I’m using a 1100mAhr LiPo battery which is charged using the internal charger.
If I accidentally run the battery flat, 2.8V, I cannot get the internal charger to get the system working again. When I connect an external power source, thebattery starts to charge to about 3V. At this point RF activity starts, and the voltage collapses back down to 2.8V. The UC864-G appears to be left in a ‘crashed state’, consuming lots of current (<100mA). This battery charger then goes to the small ‘recovery mode’ current and the battery never get back above 3V. I really need a mothed to stop the automatic network registration that occurs with this model. The power source for charging is 5.0V current limited to 400mA as required.
Hit enter to search or ESC to close
Knowledge Base & Download Zone