I’m having problems using the #SSENDEXT command every time I issue the command get an ERROR response from the module. Is there any additional configuration required for this command to work?
Does the firmware on my module support the command? The module is running 07.03.400 (If not how can I get a version that supports the command)
Hi
I’m having problems using the #SSENDEXT command every time I issue the command get an ERROR response from the module. Is there any additional configuration required for this command to work?
Does the firmware on my module support the command? The module is running 07.03.400 (If not how can I get a version that supports the command)
Hi Richard,
#SSENDEXT was added in 7.03.xx2.
How do I get new firmware, tools and documentation files from Telit?