I am using GL868-DUAL modem.I tried to load a python script as directed in the manual.But after sending the WSCRIPT command,the device does not send me any prompt as said in the manual.It waits for sometime,and then displays
">>>
Error"
at once. Any suggestions?
What terminal software are you using, did you try another one? Do you have the serial port set to 115200, hardware flow control?
Hi,
I am using Hyperterminal for Windows 7.I also tried other softwares such as Terminal v1.9b and also an online software m2msupport.net/m2msupport/module-tester.Yes,I did exactly as mentioned in the manual.Set the baud rate to 115200 and hardware flow enabled!
please , post firmware version (at+cgmr), if you are using hw flow control or not, post the script you are trying to upload
Hi,
I am using GL868-DUAL modem.I tried to load a python script as directed in the manual.But after sending the WSCRIPT command,the device does not send me any prompt as said in the manual.It waits for sometime,and then displays
">>>
Error"
at once. Any suggestions?
What terminal software are you using, did you try another one? Do you have the serial port set to 115200, hardware flow control?
Hi,
I am using Hyperterminal for Windows 7.I also tried other softwares such as Terminal v1.9b and also an online software m2msupport.net/m2msupport/module-tester.Yes,I did exactly as mentioned in the manual.Set the baud rate to 115200 and hardware flow enabled!
please , post firmware version (at+cgmr), if you are using hw flow control or not, post the script you are trying to upload