LE910v2 digital voice audio interface: Does it already support SLAVE mode?

5 thoughts on “LE910v2 digital voice audio interface: Does it already support SLAVE mode?

  1. Hello, I would like to check if support for SLAVE I2S digital voice audio mode has been added to LE910v2 modem.  I am aware that the it only supports MASTER mode in the 2014 document: Telit_LE910-LE920_Digital_Voice_Interface_Application_Note_r3.  

    Was hoping that after 3 years, this has been added =).

    Thank you very much

    1. Hi Louie,

      I wonder which modukle are you using, since LE910-V2 has DVI master/slave since the beginning of its life.

      But you are talking about Telit_LE910-LE920_Digital_Voice_Interface_Application_Note_r3. which is related to qualcomm based module not V2.

      To be sure what are we talking about please elt me know your FW version and/or one valid IMEI

      1. Hi Louie,

        I wonder which modukle are you using, since LE910-V2 has DVI master/slave since the beginning of its life.

        But you are talking about Telit_LE910-LE920_Digital_Voice_Interface_Application_Note_r3. which is related to qualcomm based module not V2.

        To be sure what are we talking about please elt me know your FW version and/or one valid IMEI

        Hi Luca,

        Thank you for your reply.  I only found one document (screenshot attached) in Telit Download Zone on the LE910 that explains the DVI application note and I assumed (I stand corrected) that it also applies to LE910v2.  

        Is it possible if you can point me where I can get this LE910v2 DVI document (or perhaps e-mail)?  I really would prefer if it can also work on SLAVE mode.

        Thank you again. 

    1. Thank you very much, Luca.  You can consider the question in the post title, answered.