LE910: DVI Question

2 thoughts on “LE910: DVI Question

  1. Hello,

    The HE910 uses the AT#DVIEXT command to configure audio to use PCM or I2S modes. Does the LE910 have an equivalent command? We would like to configure the LE910 to use PCM mode (Burst) rather than I2S mode. This is how we have used HE910 in the past.

    Thank you!

    1. Hello Stephen,

      LE910 is based on a different chipset so the DVI is way different from HE910.

      But you can adapt your board I think. Attached you’ll find the two waveform comparison, you’ll see the difference.

      To get this scecnario you have to use

      AT#DVICFG=0,1,2,1,2

      command