Output power of H24

One thought on “Output power of H24

  1. Hello,

     

    I am in a situation where I would need to make absolutely sure that the H24 will not transmit any data (for power consumption reasons). A board rework is planned, but Iactually need a work around.

     

    Going in “airplane mode” is not a good solution for me, as this one may take too much time to re-register to the network.

     

    One option I thought about is reducing the RF output power for a couple of seconds. Is there  special command that would allow to do that?

     

    Best regards and thanks in advance

     

    Samuel