If configured as a "Router" can the NE50-868 module acquire telemetrie or data (serial and/ or discrete I/O) alsdo on its own interfaces, or is the data acquisition in the "Router" mode restricted to lower level routers and end points?
Hi,
yes, Telemetry function is available also on module set as Router.
Ok, sounds good!
Hence, it should be possible to apply the "Low Power Mode" procedure as described in section 7 of "Low Power Mesh protocol User Guide" also to a router’s own serial input. Is there any specific register setting required to accomplish this?
If configured as a "Router" can the NE50-868 module acquire telemetrie or data (serial and/ or discrete I/O) alsdo on its own interfaces, or is the data acquisition in the "Router" mode restricted to lower level routers and end points?
Ok, sounds good!
Hence, it should be possible to apply the "Low Power Mode" procedure as described in section 7 of "Low Power Mesh protocol User Guide" also to a router’s own serial input. Is there any specific register setting required to accomplish this?