ME910C1: How to know the module is ready to accept AT commands

4 thoughts on “ME910C1: How to know the module is ready to accept AT commands

  1. Hi,

    In some Telit modules there is a software ready (SW_RDY) line which indicates the host controller about the readiness of accepting the AT commands, so is there any way to idendify that the module(ME910-C1) is up and ready to accept AT command?

    regards

    kk

    1. Dear Krishna Kishore,

      there is any SW_RDY line. You have to follow the flow chart showing the proper turn on procedure at page 34 of the ME910 HW User Guide.

      1. hi Andrea,

        Yes i have gone through the power on flow sequence, do you mean to say that SW_RDY is not available in this module and PWRMON is the only one signal we need to rely on?

        regards

        kk