Where i can find information about JN3 commands?
For example i need set that JN3 send to UART only $GPRMC sentence and 3 seconds interval?
P.S. Cosmin! Roundsolutions forum was more active 😉
Hi Pranas, good to see you here!
JN3 is SirfIV based, it supports 5Hz output with all messages enabled, or you can set per command output interval. The command to use is $PSRF103, see "NMEA Reference Manual" and "JN3 EVK User Manual".
NMEA Reference Manual is what i am looking for.
Thank you a lot!
How do I get new firmware, tools and documentation files from Telit?
& check your email.
Hit enter to search or ESC to close
Knowledge Base & Download Zone