JN3 Messages

6 thoughts on “JN3 Messages”

1. Hi,

   I’m using JN3 and it sends only

   $PSRF150,1.

   Do you know what happens with the module? How can I configure the module to send the

   Normal
   0

   21

   false
   false
   false

   PT-BR
   X-NONE
   X-NONE

   RMC, GGA, GSA e GSV messages?

   1. Hello Micael,

       

      could you please tell me the serial number of your JN3?

      Which version of JN3 are you using? ROM based or Flash based? 

       

       

       

      Matteo Manca

      GNSS Technical Support Engineer – R&D
      Sardinia 

      1. Hi Matteo,

          Is a JN3 ROM based with serial 13235D1F05751

         1. Hello Micael,

             

            could you please send me your schematic?

             

            Anyway from the default the firmware on our JN3 starts in NMEA at 4800bps and GPRMC, GPGSV,GPGSA,GPGGA, are enable by default.

             

            The message are you seeing is the OkToSend, $PSRF150,1.

             

            Here the Command in NMEA: 

            $PSRF101,0,0,0,0,0,0,12,4*10

             

             

            Regards

            Matteo Manca 

            1. The schematic is the same to the HW user guide.

               See attached.

               Thanks

            2. Hello Micael,

                

               did you try to send a Cold start command?

                

                

               I will look into the Schematic.

                

               regards,

                

               Matteo