3 thoughts on “H/W Flow control for xE910 modules”
Hi,
Can I clarify something – are the only lines needed for h/w flow control on the UART for the xE910 modules CTS and RTS?
Should DTR/DSR be connected? (Our existing drivers don’t support these lines anyway)
Kind Regards,
Mark
RTS/CTS lines are enough for hardware flow control however DTR and DSR can be used for other useful things, make a review of them simply looking in the AT Commands Reference Guide doc.
Thank you Cosmin – that is very helpful. Will look to connect these to GPIO pins.
We use cookies to enhance your browsing experience and help us improve our websites. To improve our website, we carefully select third parties that use cookies to allow us to serve specific content and achieve the purposes set out in our cookie policy. For more information on how to make adjustments through your browser to the cookies being used on your device, please click Find Out More link. By closing this banner or continuing to browse our website, you agree to our use of such cookies. FIND OUT MORE
Hi,
Can I clarify something – are the only lines needed for h/w flow control on the UART for the xE910 modules CTS and RTS?
Should DTR/DSR be connected? (Our existing drivers don’t support these lines anyway)
Kind Regards,
Mark
RTS/CTS lines are enough for hardware flow control however DTR and DSR can be used for other useful things, make a review of them simply looking in the AT Commands Reference Guide doc.
Thank you Cosmin – that is very helpful. Will look to connect these to GPIO pins.
Kind Regards,
Mark