6 thoughts on “Home automation application on/off switch and light”
Dear Sir,
Please help to resolve issue.
1. If we use endpoint 0xb as switch and 0xc as light , where these endpoint physically in module? 2. How can I handle 240 Endpoint without external microcontroller?
We use cookies to enhance your browsing experience and help us improve our websites. To improve our website, we carefully select third parties that use cookies to allow us to serve specific content and achieve the purposes set out in our cookie policy. For more information on how to make adjustments through your browser to the cookies being used on your device, please click Find Out More link. By closing this banner or continuing to browse our website, you agree to our use of such cookies. FIND OUT MORE
Dear Sir,
Please help to resolve issue.
1. If we use endpoint 0xb as switch and 0xc as light , where these endpoint physically in module?
2. How can I handle 240 Endpoint without external microcontroller?
Best Regards,
Diwakar Singh
PLEASE post in the appropriate category!
Specify product and firmware.
Module :- ZE61-2.4
f/w
Zex1pro_HEATCOOLUNIT_RO .S28
Zex1_PRO_SWITCH_RO_S28
Zex1_PRO_ONOFFLIGHT_RO.S28
HA_SWITCH_Light_HCU_Package
Regards,
Diwakar
Dear Sir,
In ZE61-2.4 module (F/w – Home Automation profile HA ( 0x0104))
Device id 0x0000 (on/off Switch)
and Device id 0x0001(On/off Output)
Which pins are used for (on/off Switch) and (On/off output) cluster id 0x0006.
We are able to send data to module (COOR) and it is sending ACK message, but we are not able to see any physical activity at End device.
Please let me know, how to test it and what the right procedure.
Thanks,
Diwakar