3 thoughts on “HE910-G resting issue during \”AT#AGPSSND\”. command”
Dear Sir,
We are using HE910-G module in asset tracking device. in this, we have to take GNSS location from module built-in GNSS device and send to the server. if GNSS is not available in that case we are requesting triangular based location from the module.
previously we were using 12.00.006 module firmware that time everything is working fine but when we updated module firmware 12.00.007. module encountering resets during “AT#AGPSSND”.
We have tested this issue with third party evaluation board and Telit EVK-2 and HE910-G Interface board. but the result remains same.
We use cookies to enhance your browsing experience and help us improve our websites. To improve our website, we carefully select third parties that use cookies to allow us to serve specific content and achieve the purposes set out in our cookie policy. For more information on how to make adjustments through your browser to the cookies being used on your device, please click Find Out More link. By closing this banner or continuing to browse our website, you agree to our use of such cookies. FIND OUT MORE
Dear Sir,
We are using HE910-G module in asset tracking device. in this, we have to take GNSS location from module built-in GNSS device and send to the server. if GNSS is not available in that case we are requesting triangular based location from the module.
previously we were using 12.00.006 module firmware that time everything is working fine but when we updated module firmware 12.00.007. module encountering resets during “AT#AGPSSND”.
We have tested this issue with third party evaluation board and Telit EVK-2 and HE910-G Interface board. but the result remains same.
Please refer below command sequence.
AT+CGMM
HE910
OK
AT+CGMR
12.00.006
OK
AT+CREG?
+CREG: 0,1
OK
AT#HTTPCFG?
#HTTPCFG: 0,””,80,0,””,”******”,0,120,1,300,0,0
#HTTPCFG: 1,””,80,0,””,”******”,0,120,1,300,0,0
#HTTPCFG: 2,”m2mlocate.telit.com”,9978,0,””,”******”,0,120,1,300,0,0
OK
AT#SGACT=1,0
OK
AT+CGDCONT=1,”IP”,”internet”,”0.0.0.0″,0,0
OK
AT#SGACT=1,1
#SGACT: 100.116.255.118
OK
AT#CACHEDNS=1
OK
AT#AGPSSND
OK
#AGPSRING: 200,12.982478,77.600944,0,1266,””,0
#AGPSMPRRING: 1
AT#SGACT?
#SGACT: 1,1
#SGACT: 2,0
OK
Can you tell me what is the issue?
Thanks,
Diwakar Singh
Thanks for your support.