ON_OFF is pulled LOW for 5 seconds which causes the PWRMON to go HIGH. DTR and RTS are then pulled LOW by the AP.
Problem is that CTS is stays HIGH and (understandably) if any data is sent to the modem it isn’t echoed back or responded to. So far I haven’t been able to send any data to the modem.
Any ideas as to why this could be happening?
Is it running an application that imports SER, in that case do you know #STARTMODESCR settings?
ON_OFF is pulled LOW for 5 seconds which causes the PWRMON to go HIGH. DTR and RTS are then pulled LOW by the AP.
Problem is that CTS is stays HIGH and (understandably) if any data is sent to the modem it isn’t echoed back or responded to. So far I haven’t been able to send any data to the modem.
Any ideas as to why this could be happening?
Is it running an application that imports SER, in that case do you know #STARTMODESCR settings?
A firmware upgrade will clear things.
A FW upgrade has solved this, thank you.
–