I am new in this forum.I want to establish a ppp connection with atdt dialup.But it hangs on atdt*99# command and while using atdt commands with all parameters(APN,LInkProtocol and CID value) it shows “No Carrier”.Any Solutions?Thank You.
Please post a complete relevant code. What means "hangs", what symptoms?
Thank you for the response.
As per the question,
The modem ‘hangs’ means it does not communicate further until it is rebooted.It does not reply anything nor takes any command till then.
Try dialing ATDT*99***1#.
Hi Cosmin,
The results with this command is no different than the previous.It still behaves as it did while dailing ATDT*99#.
Set AT&K0 if you are not using hardware flow control for your serial communication.
Hi,
The problem seemed to be in the hardware.It works now,Thank you for support Cosmin.
We use cookies to enhance your browsing experience and help us improve our websites. To improve our website, we carefully select third parties that use cookies to allow us to serve specific content and achieve the purposes set out in our cookie policy. For more information on how to make adjustments through your browser to the cookies being used on your device, please click Find Out More link. By closing this banner or continuing to browse our website, you agree to our use of such cookies. FIND OUT MORE
Hi,
I am new in this forum.I want to establish a ppp connection with atdt dialup.But it hangs on atdt*99# command and while using atdt commands with all parameters(APN,LInkProtocol and CID value) it shows “No Carrier”.Any Solutions?Thank You.
Please post a complete relevant code. What means "hangs", what symptoms?
Thank you for the response.
As per the question,
The modem ‘hangs’ means it does not communicate further until it is rebooted.It does not reply anything nor takes any command till then.
Try dialing ATDT*99***1#.
Hi Cosmin,
The results with this command is no different than the previous.It still behaves as it did while dailing ATDT*99#.
Set AT&K0 if you are not using hardware flow control for your serial communication.
Hi,
The problem seemed to be in the hardware.It works now,Thank you for support Cosmin.
Welcome Rupak, thanks for noticing us.