UL865 and at#bnd

8 thoughts on “UL865 and at#bnd

  1. Hello,

     

    It looks that UL865 module doesn’t support
    at#bnd command (there is always an “ERROR” response). Is there any newer
    firmware which supports this command?

     

    My module’s firmware version:

     

    at+gmr
    12.00.603-B063

    OK
     

    Maybe there is another way to check what radio bands are used by the module during its work?

     

    Marcin

          1. Well:

             

            Hi,

            command
            AT#BND is not supported on dual band products (as UL865) beacuse it was
            implemented for those products that have more than 2 bands.

             

          2. I think both bands are enabled and in use at the same time, with the bias (mostly used) to the 2100 band, and is operator’s policy. So not much to do.