It states in R14 of the AT command reference in section 126.96.36.199.5
” – connection timeout; if we can’t establish a connection to the remote within this timeout period, an error is raised.
10..1200 – timeout value in hundreds of milliseconds (default 600)”
So according to my calculation the default of 600 would equal 6 milliseconds!
It says the vaule is ” hundreds of milliseconds” i.e. 1/100000 = 0.00001 S
Is that correct?
1 hundred milliseconds = 0.1 second
600 hundreds milliseconds = 600 * 0.1 seconds = 60 seconds = 1 minute
Are my calculations better?
Ah yes…… thanks again, I see my mistake.
I read it as hundredths of milliseconds….
Hit enter to search or ESC to close
Knowledge Base & Download Zone