Sorry if this is the wrong place to post this but there is no section
covering the HE910/XE910 device types yet.
I was interested to know what would cause a module to send out an HTTP Reset
I am using the internal TCP/IP stack via a HTTP Get command to communicate
with a server and before i have a chance to read the server response the HE910
is sending a reset command.
As a note i have successfully used HTTP requests with other WebPages etc so believe
the process is correct. But am interested to know what sort of response
from a server would produce the reset.
Sorry i don’t have the firmware number on me but will update as soon as
Thanks for your time
can you post the list of commands and settings used?
The module can close the socket for inactivity <maxTo> or escape sequence +++.
Other causes could be PDP context deactivation requested by the network.
I assume you have the control of the HTTP server, since you can log the packets received.
Hit enter to search or ESC to close
Knowledge Base & Download Zone