JN3

4 thoughts on “JN3

  1. Hello,

     

    Where i can find information about JN3 commands?

     

    For example i need set that JN3 send to UART only $GPRMC sentence and 3 seconds interval?

     

    Thank you

     

    P.S. Cosmin! Roundsolutions forum was more active 😉

    1. Hi Pranas, good to see you here!

       

      JN3 is SirfIV based, it supports 5Hz output with all messages enabled, or you can set per command output interval. The command to use is $PSRF103, see "NMEA Reference Manual" and "JN3 EVK User Manual".