I’m using JN3 and it sends only
Do you know what happens with the module? How can I configure the module to send the
RMC, GGA, GSA e GSV messages?
could you please tell me the serial number of your JN3?
Which version of JN3 are you using? ROM based or Flash based?
GNSS Technical Support Engineer – R&D
Is a JN3 ROM based with serial 13235D1F05751
could you please send me your schematic?
Anyway from the default the firmware on our JN3 starts in NMEA at 4800bps and GPRMC, GPGSV,GPGSA,GPGGA, are enable by default.
The message are you seeing is the OkToSend, $PSRF150,1.
The schematic is the same to the HW user guide.
did you try to send a Cold start command?
I will look into the Schematic.
Hit enter to search or ESC to close
Knowledge Base & Download Zone