AT$GPSAV not being recognized as a valid AT command

2 thoughts on “AT$GPSAV not being recognized as a valid AT command

  1. Hello all,

     
    I am currently using a GE864-GPS device (on an EVK2 board). When using a PC terminal software (like hyperterminal) and sending the AT commands AT$GPSAV or AT$GPSAI, I receive an error reply on my terminal window.

     

    E.g.:

    AT$GPSAV=?
    ERROR
    AT$GPSAV?
    ERROR

     

    Are the  AT$GPSAV and  AT$GPSAI valid AT commands, as  mentione din the AT manual? It is as if the commands are not recognized.

    BTW  AT$GPSAT is set to 1.

     

    Current gps software:

    $GPSSW: GSD4e_4.1.0-P1 12/20/2010 354TELIT100

     

     

    Regards,

    -Frank

    1. There is a note in AT Commands Reference Guide, page 45, regarding AT$GPSAV:

       

      25
       GE864-GPS Excluded