Entering to CMUX mode and enable Remote Sim through Python script

One thought on “Entering to CMUX mode and enable Remote Sim through Python script

  1. Hello!

    I would like to know if it’s possibly

    I want to write a python script  which will be loaded to module(GL865 QUAD)  singly and then each time during module start up it will be run. Script will sent to module AT commands for entering to CMUX mode:

     

    • ATE0V1&K3&D2,
    • AT+IPR=57600,
    • AT#CMUXMODE=1,
    • AT+CMUX=0
    Then after entering to CMUX mode script must enable Remote Sim on 2-ond cmux virtual channel(send  appropriate command). Finally, after initialization proccess I want to work with cmux VP0 as with AT channel, with cmux VP1  – as with Remote Sim using ASC0 Physical port.
     
    Script must do initialization procedure, set up CMUX and Remote Sim. And my application must work only through CMUX with at channel(VP0) and remote sim(VP1) .
     
    Is it posibly to realize, can you give some tips about realization?