I am using GL868-DUAL modem.I tried to load a python script as directed in the manual.But after sending the WSCRIPT command,the device does not send me any prompt as said in the manual.It waits for sometime,and then displays
at once. Any suggestions?
What terminal software are you using, did you try another one? Do you have the serial port set to 115200, hardware flow control?
I am using Hyperterminal for Windows 7.I also tried other softwares such as Terminal v1.9b and also an online software m2msupport.net/m2msupport/module-tester.Yes,I did exactly as mentioned in the manual.Set the baud rate to 115200 and hardware flow enabled!
please , post firmware version (at+cgmr), if you are using hw flow control or not, post the script you are trying to upload
Hit enter to search or ESC to close
Knowledge Base & Download Zone