Extended Call Monitoring does not send a message if the incoming call has been hang up

2 thoughts on “Extended Call Monitoring does not send a message if the incoming call has been hang up”

1. Hi !

   Sorry my english

   I caught the error in UC864E ( FW 08.01.009-B004 and earlier ) with command “Extended Call Monitoring”
   If start an incoming call to the modem, and then reset the modem does not issue a message on the call

   example:

   at#selint=2
   OK

   at+fclass=0
   OK

   at#dialmode=2
   OK

   at#ecam=1
   OK

   I started to call on the modem

   #ECAM: 0,6,1,,,

   RING

   RING

   I hang up, but the modem has not sent a message #ECAM: 0,0,1,,,

   In other modems ( example LE910 FW=17.00.523 ) I get a message from the modem
   Please correct the error and send me the new firmware

   1. Dear Evgeniy,

      the #ECAM: 0,0,1,,, is only sent out after an ATH.

      This is the behavior of the UC864 and other Telit modules like HE910/GE910/UE910 family and our 2G modules V2 and V3.

      It is true that LE910 instead is sending out this URC, anyway it should be considered a new feature for the UC864.
      

      Considering that this product is currently in EoL, it won’t be possible to satisfy this request.