I am using GL865 with 2 DTEs connected on ASC0 and ASC1, and AT#SII=1. The DTEs are 2 MCU and they can’t run Telit serial port MUX tool. Both shall be called by a remote modem through CSD. When I remotely enter the ATD<..> command I see the first RING on both ports but only ASC0 goes on ringing and finally gives CONNECT. My question is, can I use CSD also on ASC1? in other words, there’s a way to switch between the two ports, to decide which one can "answer" the call?
Check ATS0 on both instances set it to 0 to disable auto-answwer at your will.
We use cookies to enhance your browsing experience and help us improve our websites. To improve our website, we carefully select third parties that use cookies to allow us to serve specific content and achieve the purposes set out in our cookie policy. For more information on how to make adjustments through your browser to the cookies being used on your device, please click Find Out More link. By closing this banner or continuing to browse our website, you agree to our use of such cookies. FIND OUT MORE
I am using GL865 with 2 DTEs connected on ASC0 and ASC1, and AT#SII=1. The DTEs are 2 MCU and they can’t run Telit serial port MUX tool. Both shall be called by a remote modem through CSD. When I remotely enter the ATD<..> command I see the first RING on both ports but only ASC0 goes on ringing and finally gives CONNECT. My question is, can I use CSD also on ASC1? in other words, there’s a way to switch between the two ports, to decide which one can "answer" the call?
Check ATS0 on both instances set it to 0 to disable auto-answwer at your will.